Installing Interior Plantation Shutter Hinges

When you’re ready to add new plantation shutters to your home, one of the first things you should do is upgrade the hinges. The standard option is a mortise hinge. This is the most common type of plantation shutter hinge. However, it’s not the only choice you have. Other materials are available as well. Some of these materials are made to withstand moisture, such as ABS polymer and premium polyresin 3.

Typically, plantation shutters open to the right. To install new hinges on these shutters, you’ll first need to remove any existing ones. You’ll need a Phillips head bit to attach the new hinges. Once you’ve inserted the screws, you can ask a helper to hold the open shutter against the wall, and adjust it so that the hinges are inside the jamb when the shutters are parallel to the wall.

 

If you want to replace an interior plantation shutter, the hinges will need to be replaced. Most hinges are configured to open to the right. Then, you’ll need to remove the hinge pins. Then, you’ll need to flip the shutter over and place them on the wall with the screws. Once you’re done, you can turn the unit and adjust the hinges so that they clear the jamb when the shutter is parallel to the wall.

 

If you’re looking for new shutters, a professional can install them for you. If you have shutters with many louvers, you’ll need to measure them in three places. Then, you’ll need to take measurements of each of the window shutters. Then, you’ll need to determine which size shutters you need. Using a tape measure isn’t enough. Instead, you need to get a folding rule with sliding extension. A Vix bit can also be used to drill a pilot hole.

 

When choosing interior plantation shutter hinges, it’s important to consider how the shutter will open and close. If the shutters are retrofitted, they will remain in plain sight when they’re open. To achieve a good look, shutters should be parallel to the wall when they’re closed. The fold-point of the hinges must be protruding out from the casing when the shutters are opened.

 

To install shutters, you need to drill two pilot holes in the window jamb. The first hole should be drilled about half an inch deep and should accommodate both hinge leaves. The next hole should be drilled in a place where the screw is already installed. If the screw is already in place, then you’re ready to mount the shutters. But it’s important to note that some of the types of interior plantation shutters are not compatible with surface mounted hinges. Unlike these, surface mounted hinges can cause an uneven gap between the window jamb and the shutter, so they shouldn’t be installed in a room that’s not designed for it.

 

The installation process is simple and fast. Before hanging the shutters, mark the wall where the hinges will fall. Then, set them into the window opening. Then, hang the hanging strips and fasten them with a screwdriver. After you’ve installed the hinges, you’ll need to install the shutters. This is a relatively easy and quick process, but make sure you follow the manufacturer’s instructions.